Water temperature machines have been used more often, but there are still customers who don't understand the equipment. They often have problems with the reaction equipment and can't use them. The new equipment is generally not problematic, but the manufacturer does not have an accurate guide to the correct use of water temperature. The discharge of the machine and the fault alarm, now the first step and troubleshooting of the water temperature machine:
The water temperature machine is first connected to the inlet and outlet. Pay special attention to the circulating water inlet and outlet indicated by the water temperature machine. The general water temperature machine will have a water purification filter at the water inlet. Then connect the connection tube of the mold and turn on the power. Check that all valves used are open.
After the preparation is completed, you can press the power button to turn on the power. At this time, there may be a reverse alarm. The troubleshooting method is to change the power cable. If this is normal, then there may be a media alarm. In order to prevent the safety of the water inlet valve, it is necessary to check whether the circulating water is normal. If it is normal, it indicates that the water pressure is too low. Adjust the pressure switch, only the alarm pump does not start. After the alarm is discharged, the device can set the temperature after a few minutes of cycle, and it can be used normally. If there is a fault alarm during the use, you can see if there is any troubleshooting method in the instruction manual.
Concerned about surprises
Label: The first thing to use when using the mold temperature machine
Previous: Fan speed, current and fan air volume, pressure and efficiency Next: Why the gear oil pump will cut off oil, no oil and eliminate it
Automatic Sliding Door Machine,Automatic Door Machine,Sliding Door Machine,Automatic Door Operator Korea
Caesar door control co.,ltd , https://www.caesar-door.com