Wash powder or toilet liquid to remove mold to remove mildew, first wet the moldy wall or floor with water, and then sprinkle with detergent or toilet liquid, wait for 5-10 minutes after repeated scrubbing with a mop . However, it is difficult to avoid corners or crevices that are difficult to clean, or when it takes too long to mold, it is difficult to remove them at one time. This can be scraped with a knife or sandpaper repeatedly, and then sprinkled with washing powder or toilet liquid can be wiped off. Ps: To prevent recurrence of such problems, first check the shower nozzle, water pipes, etc. to ensure that there is no water leakage or dripping. Second, open doors, windows or exhaust fans to ensure ventilation of the bathroom. , or open the door for ventilation. The last step is to clean up and prevent long-term accumulation. 
The outer wall of the bathroom may be wet and the outer layer of the bathroom may be low. There are two reasons for the appearance of the outer wall of the bathroom: 1. There is a problem with the internal water pipeline in the wall, and water seepage occurs, which leads to mildew on the outer wall of the bathroom. low; 2. The bathroom has no waterproof layer or the waterproof layer is too low. The moisture in the bathroom penetrates into the wall. If it is an internal water pipeline problem, it should be replaced in time, but it is quite troublesome to replace it. If the problem is not particularly serious, you can choose to scrape the exterior wall decoration and apply moisture protection. If the bathroom does not have a waterproof layer or the waterproof layer is too low, waterproofing of the bathroom should be re-instated, and waterproofing of special parts such as yin and yang angles, toilet roots, etc. should be enhanced. For the bathroom waterproof specification, reference can be made to the provisions of the “Construction and Decoration of Houses†specification: The waterproof layer of the bathroom wall shall not be less than 1800mm.
Bathroom life coup
Magnetic rods are exploited in industries or sectors where purification of materials is a requirement to achieve optimum quality. This type of separator rods is used for removal purpose of tramp metals from processed liquids and dry materials. This is one type of separator which assists in the removal of ferrous contaminants from areas which are difficult to clean. Engaged as Magnetic Rod suppliers our responsibility becomes even more critical as we need to validate and check all the materials coming out of the manufacturing units. As part of the process of attaining quality products, the separation rods are made to be placed at critical points of the equipment.
As an important part of the process of separation for attaining quality and pure products, these rods are made to be placed at critical points of the efficient and applicable equipment.
Application wise magnetic rods are utilized in processing industries where the separation between magnetic and non-magnetic materials can be carried out. Food production, pharmaceutical industry, plastic industry, chemical industry, agricultural industry and recycling industries are areas where the importance of such rods is noticeable. Thus we as Magnetic Rod suppliers supply the products which not only purify the material but also protect any machinery to get affected.
Magnetic Rod
Magnetic Rod,Filter Magnetic Rod,Standard Magnetic Filter Bar,Magnetic Sheet,Magnetic Bars
Jinyu Magnet (Ningbo) Co., Ltd. , https://www.magnetbonwin.com