Bearing heaters, also called bearing induction heaters, induction heaters, electromagnetic induction heaters, are a type of heating tool. Heating element and platform integration, safe, reliable, easy to use. Mainly used for bearing, gears, bushings, bushings, diameter rings, pulleys, shrink rings, connectors and other types of metal parts heated, the bearing heater expands by heating, to meet the need for interference assembly.
Installation and debugging 1, short-circuit heating: The host is a special structure of the transformer, movable yoke used to directly wear sleeve bearings or other heated workpiece. During operation, the main unit is turned on, and a short-circuit current is induced in the workpiece and heated.
2. Place the yoke on the end face of the main core.
3, check the plug and socket wiring is consistent, the ground should be good, and then plug into the power outlet with a control switch.
4. Turn the function selection switch to the manual position and close the power supply. The red indicator light is on.
5, press the start button, the host power, then the green indicator light is red light; press the stop button, the red light is green. At this point, debugging is completed and it can be put into use.
Operation procedure 1. According to the inner diameter of the bearing, select the appropriate yoke, and place the yoke of the bearing on the series onto the end face of the main core.
2. During the heating process, use a point thermometer to measure the temperature rise at the end plane of the inner ring of the bearing. When the temperature rise meets the requirements, count the time, stop the heating, remove the yoke, and remove the bearing to assemble.
3. Continuously heat the bearing of the same specification, switch the function selection switch to the time-controlled position, set the heating time, and automatically turn off the power when the bearing is heated to the set time.
4. After the work is completed, switch the function selection switch to the stop position and cut off the position.
Installation and debugging 1, short-circuit heating: The host is a special structure of the transformer, movable yoke used to directly wear sleeve bearings or other heated workpiece. During operation, the main unit is turned on, and a short-circuit current is induced in the workpiece and heated.
2. Place the yoke on the end face of the main core.
3, check the plug and socket wiring is consistent, the ground should be good, and then plug into the power outlet with a control switch.
4. Turn the function selection switch to the manual position and close the power supply. The red indicator light is on.
5, press the start button, the host power, then the green indicator light is red light; press the stop button, the red light is green. At this point, debugging is completed and it can be put into use.
Operation procedure 1. According to the inner diameter of the bearing, select the appropriate yoke, and place the yoke of the bearing on the series onto the end face of the main core.
2. During the heating process, use a point thermometer to measure the temperature rise at the end plane of the inner ring of the bearing. When the temperature rise meets the requirements, count the time, stop the heating, remove the yoke, and remove the bearing to assemble.
3. Continuously heat the bearing of the same specification, switch the function selection switch to the time-controlled position, set the heating time, and automatically turn off the power when the bearing is heated to the set time.
4. After the work is completed, switch the function selection switch to the stop position and cut off the position.
Non-tapping screws are machine Screw, the pieceworker to be fastened must be tapped with taps in the screw hole in advance to match the screw threads.
The difference between tooth screws and other screws depends on whether they can be used together with nuts. Tooth screws can be used with nuts. And relative to the screws of other teeth, there are self-tapping screws. The nut of this kind of screw has no bow teeth. As for the standard teeth and fine teeth are only different pitch, it is the nut of the machine screw
Hex Machine screw,pan machine screw,flat machine screw,truss machine screw,Hexagon socket screws
Shenzhen Lanejoy Technology Co.,LTD , https://www.copper-nut.com