1. The necessary tools for installing the handrail: Aluminum alloy cutting machine, impact drill (with M12 drill bit), hand drill (with M head) grinding machine, socket wrenches No. 10 and No. 14, utility knife, tape measure, scissors, pencil, mark Pens, hammers, etc.
2, the installation height, the general handrail installed on the wall to the highest point of 90 cm from the ground, 83 cm hole.
3. Measure the length and measure the length of the section of the handrail installed from left to right.
4ã€After measuring the length, cut the aluminum alloy and the length of the aluminum alloy is (the total length of the measurement minus the length of the elbow 16 cm (an elbow 8 cm) minus the distance between the two sides need to stay This interval is generally 1-2 cm
5, (Drilling bracket hole position) from the ground to measure the vertical height of 83 cm for marking holes, buried expansion screws, left and right spacing according to the actual situation to arrange.
6, (bending the elbow) put the left and right elbows on the aluminum alloy, do a good job mark fixed drilling elbow!
7. (Install aluminum alloy) Place two aluminum alloys with good elbows on the wall with expansion screws, adjust the left and right spacing, and drill holes in the center line of the aluminum alloy corresponding to the position of the expansion screw.
8, install fixed aluminum alloy (with bumper side down), install bumper bar
9, (installed surface cover) with a tape measure from the left elbow to the right elbow distance, with the cutting machine to measure the size of the next saw (face cover is best cut 1mm), the surface cover buckle on the aluminum alloy, Wipe clean face cover, installation is complete!
If you have other questions, please contact us
2, the installation height, the general handrail installed on the wall to the highest point of 90 cm from the ground, 83 cm hole.
3. Measure the length and measure the length of the section of the handrail installed from left to right.
4ã€After measuring the length, cut the aluminum alloy and the length of the aluminum alloy is (the total length of the measurement minus the length of the elbow 16 cm (an elbow 8 cm) minus the distance between the two sides need to stay This interval is generally 1-2 cm
5, (Drilling bracket hole position) from the ground to measure the vertical height of 83 cm for marking holes, buried expansion screws, left and right spacing according to the actual situation to arrange.
6, (bending the elbow) put the left and right elbows on the aluminum alloy, do a good job mark fixed drilling elbow!
7. (Install aluminum alloy) Place two aluminum alloys with good elbows on the wall with expansion screws, adjust the left and right spacing, and drill holes in the center line of the aluminum alloy corresponding to the position of the expansion screw.
8, install fixed aluminum alloy (with bumper side down), install bumper bar
9, (installed surface cover) with a tape measure from the left elbow to the right elbow distance, with the cutting machine to measure the size of the next saw (face cover is best cut 1mm), the surface cover buckle on the aluminum alloy, Wipe clean face cover, installation is complete!
If you have other questions, please contact us
aluminium profile for kitchen cabinets price from factory
Cabinet Aluminium Profiles,Aluminium Profile Cupboard,Aluminum Profile Kitchen Cabinet,Aluminium Profile For Kitchen Cabinets
GuangDong XinCheng Material CO.,LTD , https://www.xin-alu.com