Home>Bearing knowledge>Characteristic analysis of angular touch ball bearings |
Analysis of the characteristics of angular touch ball bearings
Source: China Bearing Network Time: 2014-08-03
/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089'; |
Most of these bearings are used for small-span rigid double-supported shafts or fine spindles; carefully adjust the clearance when using; change the axial spacing of the inner and outer rings of the bearing; adjust the internal clearance of the bearing; together Several sets of bearings are connected in parallel and give a certain amount of pre-interference; can improve the rigidity of the bearing system.
A single bearing of this type can only accept axial loads in one direction; together with other bearings to offset its additional axial force; when added to the device, the additional axial forces cancel each other; and can accept two forces upwards Axial load; and has a strong axial limit in two directions; paired devices usually use two sets of bearings with their outer ring wide end face opposite (back to back) or narrow end face opposite (face to face) two means; The back-to-back device bearing system is the most rigid. For easy pairing or grouping; some bearing plants supply pairs, three sets and four sets of bearings; Good; the load is more uniform when used; the additional axial forces cancel each other out completely.
This type of bearing is available in both separate and non-detachable types; the separate bearing is used to limit the condition of the device; the outer ring or the inner ring can be removed from the entire set of bearings to separate the device; Bearings are widely used in magneto-electric machines; so they are also called magneto-motor bearings. The types of locks on this type of bearings are on the inner ring; they can be adapted to higher speeds.
Recommend to friends comments close window
Bearing related knowledge |
What is the characteristic of the deep groove ball bearing for the analysis of the Timken thrust bearing? What combination of combined bearings? Bearing operation trajectory and method of loading |
This article links to http://
Please indicate the bearing network http://
Previous:Axial displacement of bearings Next:How to deal with the problem of imported bearings overheating
B&H TOOLS CO., LTD. , https://www.bandhtools.com