When decorating homes, pay special attention to the wallpapers at the yin and yang corners. The wallpaper processing at the yin and yang corners is related to the overall wallpaper's posting effect, and if the handling is not good, the wallpaper cracking and the like are likely to occur. Below, Xiao Bian will tell you in detail about the treatment of Yin Yang Kok wallpaper. Interested friends come to learn about it!
Sun corner wallpaper paste
The first step: Use a squeegee to carefully affix the wallpaper to and across the corner of the raised wall, but do not stick to the other wall.
The second step is to manually crease the corner of the convex wall from the top and bottom, and draw a vertical line from the ceiling to the floor 2.5cm away from the convex wall.
Step 3: Use the utility knife to cut the wallpaper along the above vertical line and guide it with a ruler.
Step 4: Carefully open the remaining wallpaper and put it on the workbench for later use.
Step 5: Use the seam pressure roller to level out the wallpaper on the overhang and add glue on the glue on the covered wallpaper.
Step 6: Cover the wallpaper and make it a good pattern. Scrape the wallpaper with a scraper and flatten it with a roller.
Yin corner office wallpaper paste
1) Treatment of the internal corner of the house without settlement
The first step: measuring from the center of the last wallpaper to the corner of the concave wall, plus 2.5cm, cut a piece of wallpaper at this width.
Step 2: Paste the wallpaper above and align it with the last attached wallpaper and level it on the corner of the recess.
The third step: use the scraper to scrape the upper part of the board to stick to the wall, and dry the glue on the scraper to earn.
Step 4: Measure the width of this section outward from the reentrant corner and add 5mm to mark the wall.
Step 5: Place a level gauge on the pencil mark to check if it is truly vertical and apply glue on the covered wallpaper.
Step 6: Align the outside of the covered wallpaper with the vertical line. The vertical line will prevail and the rest of the wallpaper in the room will be posted.
2) Treatment of the inside corners of houses
The first step - the third step: are the same as above.
Step 4: Paste another wallpaper with the previous one. Align the wallpaper and turn to the other wall.
Step 5: Flatten the inside corner on the back of the scraper at the inside corner.
*Note: Firstly, slowly slide the wallpaper to the overcast corner slowly, and slowly re-smooth the inside corner of the scraper. Do not use force to avoid hurting the wallpaper.
The sixth step: the crease repaired by the scraper at a distance of 2mm from the inside corner of the shade, and a straight knife with a utility knife to cut it from top to bottom.
Step 7: Remove excess wallpaper and wipe off excess glue with a white towel or sponge.
Switching method
The first one: First paste the entire switch, and then use a wooden handle to brush and flatten it. Then use a utility knife to draw a cross on the diagonal line above, but use appropriate force. Do not scratch the switch. Use a scraper to hold the switch. At the edge, use a knife to cut off excess wallpaper.
The second kind:
Step one: Cover the entire switch with the wallpaper.
Step 2: At the four corners of the opener, use a utility knife to cut four points toward the center.
The third step is to cut a parallel line at the edge lcm away from the long edge of the switch, but the distance from the edges of the short sides of the switch is also Icm.
Step 4: At the midpoint of the drawn equality line above, draw a vertical line with a utility knife, 3 cm from the lower edge.
Step 5: Connect the lower two points with the utility knife and the vertical line drawing.
Step 6: Cut the excess wallpaper with a utility knife with the scraper against the edge of the switch box.
Door and window method
If there is no door cover for a typical house, there are two parts of the window cover that need to be affixed to the wallpaper as follows:
Step 1: Paste the wallpaper on the edge of the nearest window from the right and left sides of the window, and place the extra stretches on the top and bottom of the window.
Step 2: Use the utility knife to draw parallel lines along the upper and lower edges of the window in the empty part of the middle window.
Step 3: Wrap the cut outs into the left and right edges of the window.
The fourth step is to overlap the extensions that have just been left on the top and bottom edges of the window with the spare parts left.
Step 5: Use a ruler along the edge of the overlapping wallpaper to match the utility knife and cut it from top to bottom.
Step 6: Remove excess wall paper and wipe excess glue with a white towel or sponge.
Editor's Reminder: Here, Xiao Bian needs to remind everyone not to ignore some small details of the decoration. For example, the angles of the sun and the corners of the wallpaper are very important, but they are often overlooked by others, so Xiao Bian feels more. It is necessary to emphasize it. The method of attaching the corners of the wallpaper to the corners of the sun and the inside corners is also an important point, and it must not be arbitrarily affixed. It is better to look at the methods and techniques summarized by Xiao Bian before the positive and negative corners of the wallpaper.
Construction Acceptance Flooring Wall Construction Wallpaper Switch Window Housing Room
New Abs Case Tape Measuring,Low Price Measuring Tape,Colorful Measuring Tape
HENAN BONTHE MEASURING TOOLS. CO., LTD , https://www.tapemeasureb.com