1. The material of the sink: The sink is also called the kitchen sink. The material must be made of steel marked with 304. Because the 304 steel has a low carbon content, the flexibility of the steel is better. It is no exaggeration. Said that this steel, ordinary pistol bullets can not be worn. At present, several brands of sinks entering B&Q have selected 304 steel, and the thickness of the sink is generally 1.0mm.

2. The production method of the sink: There are two main ways to produce the sink. One is the one-time stamping of the water flow, and the other is the welding. The welding is divided into the bottom part, the middle butt welding, the wheel welding, etc. There are several ways.

A stamped water tank is preferred. It has a good seal, but the depth of the tank is not deep enough for welding. Usually the depth is less than 18mm and the deepest bottom of the welding can reach 21mm, so customers and friends should choose a deeper one. The sink must pay attention to the degree of sealing of the weld.

3. There is no protective coating on the bottom of the sink: a protective coating is added to the bottom of the sink to silence and prevent condensation. The preferred coating is to spray the entire back of the tank with mortar. Ordinarily it is a rubber gasket attached to the bottom, which can also play a quiet sound effect.

4. The size of the sink: no problem with the length should pay attention, but the width is very important, the width should refer to the width of the cabinet surface, the standard table width is two kinds of 55CM and 60CM, but everything has a special, old house table 50CM Mostly. The sink width of the table of 55CM should be less than 45cm. The sink width of the tabletop of 60CM can be installed as long as it does not exceed 50CM. However, the width of the sink selected for 50CM countertops is narrow, and the width cannot exceed 41CM. One point is very important.

5. The installation of the sink: There are two types, above and below the table, so the sink has two types of basins, above and below the basin, which are usually made on stage, but in recent years The following style wind blows quietly, the understage type looks beautiful, gives a kind of refreshing feeling, the countertop takes care of is easier, but the cupboard company does the subordinate type to receive the processing fee.

Usually, the above-ground basins can be made into table-type and under-counter types, while the under-counter basins can only be made under-counter-type.

6. The surface treatment of the sink: after the surface treatment of the sink, the ability to prevent oil pollution has been greatly enhanced. Commonly, the surface is matte, the surface of the elegant Ya-Yin silver, and the eddy surface. Each has its own characteristics.

7. The water accessories of the sink: The water pipe of the sink should select the PVC pipe.

Decoration materials knowledge hydropower renovation kitchen decoration house counter

Schindler Elevator Spare Parts

Schindler Elevator Spare Parts, Schindler Elevator Parts

Schindler was founded in 1874 in Lucerne, Switzerland, and is one of the world`s leading providers of elevators, escalators, and moving walks, as well as maintenance and modernization services. The Group has over 1 000 branch offices in more than 100 countries, as well as production sites and research and development facilities in the US, Brazil, Europe, China, and India.

Schindler Elevator Spare Parts, Schindler Elevator Parts

CEP Elevator Products ( China ) Co., Ltd. , https://www.zjsmartcommercialescalators.com