With the improvement of people's lives, most families choose to use security doors at home in order to ensure the safety of their families and their families. Security doors, it is an effective measure to protect the family security, in addition to the correct choice of security doors, in fact, strict security door installation operation is also very important. So, what are the security door installation methods? Let's take a look at the security door installation process.
Security door installation method
Step process:
1. Before the start of construction, we should first ensure that other construction processes in the room are basically completed. According to the requirements of the design drawings, the partitions and moving doors must be positioned in a unified manner. Then the position of the door frame is determined, and the elevation of the ground and the height of the top of the door frame are accurately measured.
2. The length of the limiting slot at the top of the partition wall and the security door should be 2-4mm greater than the distance between the opposite upper and lower faces, and the groove depth should be maintained between 20-30mm. This facilitates the injection of glue. Method: Two metal decorative plate edges are drawn from the centerline of the bullet, and then the limiting groove is installed at the top of the frame according to the edge line. The wood plate in the notch is used to adjust the depth of the groove, and the adjustment may be made depending on whether the situation increases or decreases.
3, then press the door frame, in the center line just marked the logo nailed wooden bar, and then by the plywood to determine the shape and position of the outer shape of the door frame column, and then fixed, at this time should pay attention to the size of the decorative surface should be subtracted Finally, outsourcing the metal decorative surface, the seams should be installed on both sides of the middle position and ensure vertical.
4, at this point to the key steps, the use of professional suction cup to suck the board, and then 2 to 3 people holding the suction cup together to lift the plate upright and move up to the installation site. Then insert the upper part into the limit slot at the top of the door frame and put the lower part into the bottom bracket. The installation position of the right center line and the two door frames needs to be ensured to ensure that the two sides can just seal the pair of seams of the door frame. No visible seams are visible.
5. Afterwards, place a flat square bar on the inside and outside of the bottom wooden side and sandwich the door panel. Care must be taken to leave a gap of 4 mm. Afterwards, apply all-purpose adhesive to the square wooden bar and put the metal on the facing. The board is glued.
6, then in the top of the groove, the bottom slot, the gap between the door frame column glue injection, but should pay attention to the joint from the end to the end, construction can not be stopped. Method: Hold the glue gun tightly, forcefully and evenly, move along the gap, keep the speed evenly, move the plastic injection port at a uniform speed to form a uniform straight line, and finally scrape off the excess glue with a plastic sheet and clean it with a clean rag.
7, the final docking process, fixed board, or width is too large, the need to splicing, the gap should be maintained 2-3 mm, with glue into the gap, finished after the completion of the glue.
Summary: Well, the steps involved in the installation of the anti-theft door are shared here. This knowledge may be used in the future. If necessary, it can be collected. I hope to help everyone.
Pvc Twinwall Panel,Decorative Wall Panels,Pvc Decorative Panels,Outdoor Decorative Panels
PINGYUN INTERNATIONAL , https://www.pingyunconstruction.com