Installing a shower room typically involves on-site measurements and customizations based on the customer’s specific needs. This process is often referred to as a "one-stop service" in the industry. However, as a homeowner, it's still important to understand the general installation steps. Here’s a detailed guide to help you better grasp the process:
First, install the base tray. Make sure the base is level and properly aligned. Check that there is no water accumulation in the basin or at the bottom. The hose should be adjustable in length, and the base must be securely connected to the floor drain.
Next, perform a water test to ensure that the drainage system works smoothly. Then, use a pencil and level to mark the drilling spots for the aluminum frame against the wall. Use a hammer drill to create the holes.
Install the aluminum frame by inserting rubber gaskets into the holes and securing the aluminum bars with screws. After that, fix the glass panels to the base tray using screws for stability.
Attach the top tube by drilling a hole above the fixed glass and installing a support bracket. Connect the top tube to the glass using a bent sleeve to secure it in place.
Mount the shelf or frame, align it properly, and tighten the nuts to keep the glass vertical and horizontal. Be sure to apply waterproofing under the glass where it meets the aluminum frame.
Install the sliding door by attaching the hardware and hinges to the pre-drilled holes on the fixed door. Adjust the pivot points until the door moves smoothly and feels natural.
Apply water-resistant strips along the sides or bottom of the glass as needed. Seal the gaps between the aluminum frame and the wall, as well as between the glass and the base, using aluminum mesh or sealing tape.
Finally, check all parts for smooth operation and make any necessary adjustments. Tighten the screws to reinforce the structure and ensure everything is secure.
Finish the installation by applying decorative aluminum strips to the wall-mounted frames for a neat and elegant look. Wipe down the entire shower room with a clean cloth to remove any dust or residue.
For full shower room installation, start by determining the location. Adjust the foot screws on the base tray, level it, and connect the water supply. Perform a water discharge test to check for leaks before proceeding.
Fix the back panel and shower screen to the base using stainless steel screws. Assemble the side mounting brackets and secure them with the same type of screws.
Install the front glass panel and insert the sealing strip between the glass and the frame on both sides. Hang the sliding door and assemble the top cover, sealing the edges with a special mildew-resistant glass glue from Dow Corning.
Connect the power supply and test the system. Ensure that the hot and cold water connections are made using a 90-degree copper elbow to prevent direct water flow into the wiring, which could cause poor water pressure.
Test the water supply again to check for any leaks. Insert the drain pipe into the sewer line and seal the connection with glass glue before finalizing the installation.
Additionally, here are a few key tips to keep in mind during the installation:
1. If the track is not sliding smoothly, add some lubricant or peanut oil to the rollers to improve movement.
2. If the sliding door becomes loose or falls off, contact a professional to adjust the weight distribution. Clean the track with a damp paper towel and peanut oil to prevent debris from causing further issues.
3. Avoid hitting the glass with sharp objects, especially around the corners and edges, to prevent damage.
Volvo Parts,Volvo Spare Parts,Volvo Parts Truck,Volvo Motor Parts
JINING SHANTE SONGZHENG CONSTRUCTION MACHINERY CO.LTD , https://www.stszcmparts.com