IH type stainless steel chemical pump because the pump and motor coupling with the use of an extended coupling, remove the pump, do not have to dismantle the inlet and outlet pipes, pump body and motor, just remove the longer shaft in the coupling , You can disassemble the rotor parts for repair and maintenance. 1, remove the stainless steel centrifugal pump pump body drain pipe plug and the suspension body drain pipe plug, put the net pump liquid and suspension body of lubricating oil. (Note: If there are additional pumps on the pump should be removed). 2. Disassemble the connection between the stainless steel centrifugal pump body and the middle bracket, and withdraw all the rotor components such as the middle bracket, the suspension components and the pump cover from the pump body together. 3, remove the impeller nut, remove the impeller and keys. 4, the pump cover together with the sleeve, mechanical seal cover and mechanical seal and other components together from the shaft exit. Be careful not to slide the sleeve relative to the pump cover, etc., and then remove the mechanical seal cover, the mechanical seal together with the sleeve removed, and then the sleeve and the mechanical seal apart. If packing is used for the seal, remove the bushing directly from the pump cover and remove the packing gland, packing, packing ring, etc. in sequence. If the seal with a special structure, pay attention to different methods of disassembly. 5, remove the middle bracket and suspension bracket. 6, remove the pump couplings and keys. 7, remove the suspension body at both ends of the dust-proof disk and bearings before and after the cover, and then together with the shaft bearing removed from the suspension body. 8, Remove the bearing from the pump shaft. The assembly and disassembly process is reversed.
Customized Handle,Minimalist Walnut Door Handle,Aluminum Alloy Door Handle,Stainless Steel Door Handle
Guangzhou Junpai Hardware Co., Ltd , https://www.junpaihardware.com